Note: VELCRO® brand fasteners on top row cross-pieces is for counters. 3 counter models have 6 VELCRO® brand fastener cross pieces, and 5 counter models have 10 total. Only one of the three counter support assemblies (A) is shown

First-time Assembly:
Allow 30-45 minutes, power screwdriver with Phillips bit required.

• 1) Starting at one end, use rubber hammer to fully insert cross pieces into frame vertical assemblies (keep all snaps facing out, VELCRO® brand fastener pipe on top)
• 2) Insert screws on the underside of the fittings where shown () to secure the cross pieces. Use a power driver.
  GLUING CROSS PIECES VOIDS WARRANTY
• 3) Insert both notched pipes (B), with notch on top
• 4) For easy transport, corner swivels fold in.

Gazebo Setup:

• 1) Unfold bottom frame into hexagon, with snaps facing out
• 2) Make a "spider" by inserting all 6 ribs into crown
• 3) Lift the "spider", insert rib pairs (1), (2), and (3) into frame sockets
• 4) Throw top canopy over ribs, and snap it to ribs
• 5) Snap skirt on, starting at one end
• 6) Clip counter legs (A) to hexagon frame. Attach upper and lower counter support cross braces
• 7) Align counters with Velcro and press down firmly
• 8) Place optional undercounter shelves on bottom counter leg braces

Rib and Crown Setup:
1) Slip top and bottom ribs together (C), making sure pin is snapped securely.
2) Insert ribs into crown fully and snap crown straps to all top ribs. Once vinyl top is snapped on, it will hold the ribs together firmly.

Transport and Storage:
For transport and storage, fold frame and secure with bungie cords or string. Once the screws are in place, disassembly of the bottom frame is unnecessary.