First-time Assembly:
Allow 30-60 minutes, power screwdriver with Phillips bit required

• 1) Starting at one end, use rubber hammer to fully insert cross pieces into frame vertical assemblies (keep all snaps facing out, VELCRO® brand fastener pipe on top)
• 2) Use power driver to insert screws on the underside of the fittings where shown by the () symbol. GLUING CROSS PIECES VOIDS WARRANTY
• 3) Insert both notched pipes (A), with notch on top
• 4) For easy transport, corner swivels fold in. If screws 1 - 4 are removed, frame becomes more compact

Booth Setup Once It Has Been Assembled:

• 1) Unfold bottom frame into rectangle as shown with the snaps facing out
• 2) Assemble valance frame, snap on valance vinyl
• 3) Lift the valance frame, insert into frame sockets
• 4) Snap skirt on, starting at one end
• 5) Clip counter legs to front and sides of booth frame. Add upper and lower cross-pieces
• 6) Align counters with VELCRO® brand fasteners and press down firmly
• 7) Place optional undercounter shelves on bottom counter leg braces